Sherco-Auto Stack-able Add-on in-line Fuse Holder Panel & Distribution Block for ATO/ATC & ATM/MIN Blade Fuses - Automotive Marine Car Boat RV (1)

These are good fuse holders if you are going to be expanding to more circuits later.They work well, and as you can see cost more than other options.But the big advantage of these fuse holders is that it is easy to expand and add more circuits in the future, without adding an additional whole fuse box, just and another fuse holder to the line already there.Depending on the project, this may well be worth the additional cost to make the entire project uniform with all the fuses in one place.

Good, quality product that you can adjust the number of fuses. Take one star away for this expensive piece of plastic fuse holder.

One of the best features is that each fuse holder can have its own hot wire input. Or the hot wires can be easily bused together to adjacent selected fuse blocks with the provided ATC style plug in jumper. The adjacent fuse blocks are joined by dovetail (can as well be glued at the side if desired) and the screw down mounting tabs hold all blocks well. One might consider using ATC plug in manual reset breakers of your choice amperage, thereby eliminating spare fuses, and making circuit overcurrent diagnostics less of a nuisance, not having to replace fuses. Build your own fuse block stack to just your requirements: 1,2, 3, 4, 5 or whatever number of loads you want protected, with a minimal footprint for only your requirement.

This fuse holder is nice with respect to the design and overall size if you want a single fuse holder. It allows you to clip them together side by side to make a custom fuse holder for multiple fuses which is nice. However, when I read the desctiption I thought it would accomodate standard ATC/ATO fuses and mini ones as well. I was wrong the standard ATC/ATO fuses will not fit. I am not going to use this because I don't want to have to have multiple size fuses, standard and mini, in my project. Because this was my mistake, I will not be returning it and eat the cost. I will be sure to read product descriptions more closely to avoid this problem in the future. Education does cost.

Simple to mount, works. Not much else to say about it.

Not as listed. Impossible to use.These are not as listed.They have Hex Screws NOT Phillips as shown.Unless you have a hex wrench of the proper size, they are impossible to use.

I like the product if they are truly able to handle 40 amps. Terminal screws are rather small looking.Seem over priced for what they are.I didn't receive the item until 10 days after ordering. Or I would have rated this higher.

If you need a single (or multi) fuse block this might meet your needs. Multiple blocks can be stacked together if needed. I needed a single fuse block to put in-line between a solar panel and charge controller. It was easy to mount and overall satisfied the requirement. The only drawback I see is the cover was a little difficult to put on and take off. Inserting a fuse also requires quite a bit of force. It comes with a blade style "short" insert that looks like a fuse but it is NOT a fuse and a couple blue 14-16 ga spade connectors. It will accept the larger yellow 10-12 ga connectors.